首页 | 关于我们 | 联系我们
产品搜索:
环保型非金属箱式变电站
地面型箱式变电站示意图 diagrammatic drawing of over-ground box type substation
       高压、低压、变压器设备均在地面以下。设备检修可吊去大盖。操作人员由人井孔通道入13。适合在广场绿化带、公园等环境安装,不影响人们观景视线等优点。
       The high pressure.low pressure.transformer equipments is following all in theground。equipments check’s fixing can mourn to the big cover,operation personnel
From person’s well bore passage entrance.In keeping with green turn to take in thesquare, park etc.The environment install,don’t influence a people’s view view to see Line etc.Advantage.
 
注:◎在地脚螺钉附件最少预埋2处接地线杆
        ◎基础底面负重不得少于2000kg/m。
        ◎基础中各代号应根据订货产品而定
[地面型]非金属箱式变电站土建基础图
(供用户参考选用)


常用“地面型”非金属箱式变电站箱体示意图
In common use”ground type”nonmetal box type transformer
substation box body sketch map
半地理型”非金属箱式变电站统底板基础示意图
"Half geography type"nonmetal box scaleboard foundation
sketch map with all type transformer substation
 
高压主电路常用方案 high-volt main circuit common scheme
 
低压主电路常用方案 high-volt main circuit common scheme


箱式变电站,使用安装注意事项
lifting transportation of box type substation, operating nnotice
◎ 箱式站基础四周应预埋接地极,变压器和防雷地可合用,其接地电阻R。
◎ 箱式站起吊应用专用起吊工具,起吊部分必须按箱式站的标明部位。
◎ 箱式站底部与基础结合处,需用水泥浆抹封,以防水进入电缆室。
◎ 电缆进入套管后。其缝隙必须密封,以防虫、水进入。
 
◎The earth electrode should be embedded at four sides of foundation of box type substation,the volt transformer and lightning
grouding canbe exchangeable—used,its earth resistance R.
◎The special lifting tool is suggested to be applied during hoisting ofbox type substation,the lifting position is pointed to the marked position.
◎At the joint position between foundation and bottom ofbox type substation,it is suggested to adopt grout for sealing,SO as to prevent water
from enterinto cable compartment.
◎After cable enters into,the aperture must be sealed SO as to prevent water from entering
 
箱式站投运前必须检查下列
Operator must check following items befor operation of box type substation
箱式站底部与基础结合处必须水平,如遇各门开启有卡住现象,这是因为基础平面不平所至必须调整箱式变电站与基础面结合水平。调整
方法在箱式变电站底部与基础而缝隙处填塞薄铁片直至各室门开户灵活即可。
当整机装配完成后,装车发运必须注意整台箱体应和车前车后有一定距离,防止车在行路中因刹车而前后撞击,同时箱式站底架和车底板
必须用电焊焊牢,再用钢丝把底架和车底绞紧,并用绳索从顶盖到车底分几道上下扎紧。凡绳索扎到之处必须用纸板或其它软物垫好以防涂
层表面损伤。
为使运行中箱式站保持完好,最好半年或一年后对内部和外,部进行清扫和擦一次。
如发现因安装或运输中箱体外表面弄脏,可用洗涤剂擦刷,用清水冲洗即可。
 
     The joint position between foundation and bottom of box type substation must be kept horizontal,provided there is jamming phenomen on during opening door,maybe the foundation surface is not horizontal,at this time,regulating joint position betwe
en box type substation and foundation surface to be horizontal is suggested,specific regulation method is that stuffing thin iron
sheet onto joint position between foundation surface and bottom of box type substation till opening compartment door being flex
ible.After finishing assembling of complete machine,operator should make sure that there must be certain distance remaine
d between truck-body and complete box body in entrucking process,so as to prevent inpaction resulted from brakin during transportation,meanwhile,the under-frame ofbox type substation must be welded to bottom-plate of vehicle solidly,then using
steel wire to twist under--frame and vehicle bottom together tightly,bind box onto truck tightly with cord(from box top to truck bottom),operator must adopt soft material for stuffing onto cord binding position,so as to prevent surface damaging of paint layer.
     For maintaining box type substation in good condition during operation,user is supposed to clean or scrub interior and exterior of box
body every one year or half-year.
     Provided find that outside surface of box dirtied during installation or transportation,operator is suggested to use scour for scrubbing
firstly and water for rinsing secondly.


典型系统方案举例参考 Sampling reference of typical system scheme
电缆进出,终端供电,高供高计
Cable ingoing/outgoing, terminal power supply, high-volt supply and measure at high-volt side
 
电缆进出,终端供电,高供高计,低压走廊式,低压电容补偿
Cable ingoing/outgoing, terminal power supply, high-volt supply and measure at high-v
 
电缆进出,终端供电,高供低计,低压走廊式,低压电容补偿
Cable ingoing/outgoing, terminal power supply, high-volt supply and measure at high-v
 
环保型非金属箱式变电站
Environmental protection type nonmetal box type transformer substation
  
  Copyright:浙江沪变电气有限公司 All right revserd 服务热线:0577-62827072